Battery Equalization

What is Equalizing?

Equalizing is an overcharge performed on flooded lead acid batteries after they have been fully charged. It reverses the buildup of negative chemical effects like stratification, a condition where acid concentration is greater at the bottom of the battery than at the top. Equalizing also helps to remove sulfate crystals that might have built up on the plates. If left unchecked, this condition, called sulfation, will reduce the overall capacity of the battery. Equalizing is only performed on flooded batteries, and is not to be done to AGM batteries.

Many experts recommend that batteries be equalized periodically, ranging anywhere from once a month to once or twice per year. However, others recommend equalizing when low or wide ranging specific gravity (� .015) are detected after fully charging a battery.

Equalizing Procedure:

1. Verify the battery(s) are flooded type, and not AGM.

2. Remove all loads from the batteries.

3. Connect battery charger.

4. Set charger for the equalizing voltage (See Table 2 below)

5. Start charging batteries.

6. Batteries will begin gassing and bubbling vigorously.

7. Take specific gravity readings every hour.

8. Equalization is complete when specific gravity values no longer rise during the gassing stage.

NOTE: Many chargers do not have an equalization setting so this procedure can't be carried out.

Charging Voltages:

Charging batteries properly requires administering the right amount of current at the right voltage. Most charging equipment automatically regulates these values. Some chargers allow the user to set these values. Both automatic and manual equipment can present difficulties in charging. Tables 2 & 3 list most of the necessary voltage settings one might need to program a charger. In either case the original instructions for your charging equipment should also be referenced for proper charging. Here is list of helpful items to remember when charging.

1. Become familiar with and follow the instructions issued by the charger manufacturer.

2. Batteries should be charged after each period of use.

3. Lead acid batteries do not develop a memory and need not be fully discharged before recharging.

4. Charge only in well-ventilated area. Keep sparks or flames away from a charging battery.

5. Verify charger voltage settings are correct (Table 2).

6. Correct the charging voltage to compensate for temperatures above and below 80^o F. (Add .028 volt per cell for every 10^o below 80^o F and subtract .028 volt per cell for every 10^o above 80^o F)

Charger Voltage Settings for Flooded Batteries:

7. Check water level.

8. Tighten all vent caps before charging.

9. Prevent overcharging the batteries. Overcharging causes excessive gassing (water breakdown), heat buildup, and battery aging.

10. Prevent undercharging the batteries. Undercharging causes stratification.

11. Do not charge a frozen battery.

12. Avoid charging at temperatures above 120^o F.

Submitted by Mike Sundberg - 2/07/06
 

Click Your browser's "Back" button to return to the previous page
 or chose another category from the side menu.

The RV Tech Library is brought to you by the TiffinRVnetwork

Absolutely No Affiliation exists between this group and Tiffin Motor Homes Inc or the Allegro Club. This website neither endorses or discourages the use or purchase of a Tiffin product. All references, suggestions, comments, etc. contained herein are the opinions/experiences of the posters and not those of Tiffin Motor Homes Inc. or the website administrators.